Kyocera FS-6525MFP Fax System (U) Operation Guide Rev-4.2012.3 - Page 187

Fax Settings > Default fax settings Item 2 in 1 Print Description When you receive a multi-page Statement or A5 size original, this function prints 2 pages of the original at a time on one Letter or A4 size sheet of paper. Value: On, Off For details, refer to 2 in 1 Print on page 5-9. Batch Print When a multi-page fax is received, the pages are printed in a batch after all pages are received. If [Off] is set, each page is printed as it is received. Value: On, Off For details, refer to Batch Print on page 5-9. Rings(Normal) Rings (Answering Machine) Rings(FAX/TEL) Reception Remote SW Dial If the reception method is fax automatic reception, the number of rings until the machine answers a call can be changed as needed. Value: 1 - 15 If the reception method is FAX/Answering Machine Auto Switch Reception, the number of rings until the machine answers a call can be changed as needed. Value: 1 - 15 If the reception method is FAX/TEL Auto Switch Reception, the number of rings until the machine answers a call can be changed as needed. Value: 0 - 15 For Rings (FAX/TEL), this change is possible with some countries. Select the reception mode. Value: Auto (Normal), Auto (FAX/TEL), Auto (Answering Machine), Manual, Auto (DRD) If Auto (DRD) is selected, select the DRD Pattern. Value: Pattern 1 (Normal Ring), Pattern 2 (Double Ring), Pattern 3 (Short-Short-Long), Pattern 4 (Short-Long-Short) DRD reception mode is available for some countries. For details, refer to DRD Reception (Available for inch versions only) on page 7-6. To start fax reception by operation from the connected telephone set, use the following operation. Value: 00 - 99 For details, refer to Remote Switch Function on page 7-10. Encrypted Reception Turns on reception by encrypted communication. Value: On, Off If turned on, select the encryption key. For details, refer to Encryption on page 6-36. ECM RX RX Start Speed Set whether ECM RX is performed. ECM is a communication mode specified by the ITU-T (International Telecommunication Union) that retransmits data when an error occurs. Fax machines that have ECM mode check for errors as they communicate, preventing distortion of the image due to noise on the line and other conditions. Value: On, Off NOTE When there is a large amount of noise on the line, communication may take slightly longer than when [Off] is selected. Change the RX Start Speed. When communication conditions are bad, the fax may not be received correctly. In that case, set a lower RX Start Speed. Value: 9600bps, 14400bps, 33600bps NOTE Normally this should be used with the default setting. TX/RX Restriction This function allows you to send or receive originals only when communication requirements are met. For details, refer to Transmission Restriction on page 9-10. 9-8