Lexmark Monochrome Laser Complete Printer Reference (1.7 MB) - Page 145

If you agreed to return your old fuser to Lexmark in order to pay a reduced price for the new one, place the old fuser in the new fuser box and mail to Lexmark. Otherwise, discard the old fuser. Staples If you've attached an optional finisher to your Optra W810, your printer's finishing capabilities include stapling. The printer's staple capacity is 5,000 staples per cartridge, which you can purchase in boxes of three. The finisher can staple packets of up to 50 sheets of paper, and outputs them into bin 2. Sheets of staples Protective tape When the printer determines that approximately 40 staples are left in the cartridge, it displays a Staples Low message. The staple low counter then increments by one every time one of the remaining staples is used, and when the staple low limit has been reached, the printer alerts you that it is time to change the staple cartridge: • If the Staples Empty Alarm menu item in the Finishing Menu is set to Single or Continuous, the printer stops printing and sounds a series of beeps. The message Load Staples appears on the display. If you ignore this message and press Go to continue printing, the print job may not be stapled. • If the Staples Empty Alarm is set to Off, the printer displays a Staples Empty message and continues to print, but does not staple the pages. Changing the staple cartridge should clear the Staples Empty message from the display. If it does not, check to make sure the stapler is installed correctly. (For instructions on inserting a new staple cartridge, refer to the User's Reference. For information about ordering staple cartridges, see page 137.) After you insert a new staple cartridge, the printer automatically prepares the stapler to begin stapling again. Priming Stapler appears on the display as the printer tests the stapler on a single sheet of paper. (Refer to the User's Reference for more information.) Then the printer resumes printing. Printer consumables 145