Lexmark Monochrome Laser Complete Printer Reference (1.7 MB) - Page 232
properly installed., finisher to the printer is
View all Lexmark Monochrome Laser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
Finisher problems (continued) Symptom Cause A printer message says Bin 2 (the default bin for all that all linked bins are stapled and offset jobs) is full. full, but bin 1 is empty. The transport unit falls from the top of the printer when you pull away the finisher. The guide rail attaching the finisher to the printer is not properly installed. Solution The finisher stacks all stapled jobs and all offset jobs in bin 2. If bin 1 and bin 2 are linked and bin 2 is full, the printer reports that bin 1 is full also. To clear the message, remove the stack of paper from bin 2. The printer can then receive additional stapled or offset jobs. Reinstall the guide rail. When properly installed, the guide rail prevents you from pulling the finisher too far away from the printer. Refer to the Setup Guide for detailed installation instructions. Troubleshooting 232