Maytag MAH5500BWW Service Manual - Page 114

USER INTERFACE SELECTIONS: (LED Washer) machine at night or some other time to better suit the needs of the household. The user can select the setting of several features while in the User Interface Active Mode or the Main Wash Cycle. The user sets the features by pressing a key on the keypad and the machine goes into the set mode. If the machine is in the main wash cycle, additional criteria may be applied prior to changing the feature. The modes to set a feature are: • Fabric Mode • Temperature Mode • Cycles Mode • Delay Mode • Signal Mode • Options Mode FABRIC MODE When a Fabrics key is pressed, the last cycle that was not a Quick, Rinse, or Spin cycle, will be recalled. Each Fabrics key (Cotton/Sturdy, Wrinkle Free, Delicates, Handwash, ) remembers the wash/rinse temperature settings, max extract option, extra rinse option, and wash settings. The consumer can select the time delay from 1 hour to 9 hours in increments of 1 hour. The user shall press the delay button for each 1 hour increment. Holding down the delay wash key will advance through the one hour increments to off and start over again. The delay time (in hours) shall be shown in left digit and an ‘H’ (for hours) shall be shown in the right digit of the display. If delay wash has been selected, but Start/ Pause has not been pressed to initiate it, then the Start/Pause LED will flash off and on to indicate that it must be pressed. The Start/Pause key must be pressed to initiate a delay wash cycle. Once it has been pressed, the Start/Pause LED will stay on constant and the time will begin to count down and the display will indicate hours of delay remaining. When one hour of the delay is reached, the time will be shown in minutes in the two digits of the display. TEMPERATURE MODE Four discrete wash/rinse temperature selections are provided, each with an Note: If a regular cycle has been running for more than five seconds, the delay wash key will be locked out. associated LED. Up and down arrow keys are used to make the wash/rinse selection. Holding down one of these keys will advance at a rate of one level per half second. Wash/rinse selection will not wrap around. SIGNAL MODE The volume level of the end of cycle signal is adjustable. The sound ranges from “off” to “3” in increments of 1. The user will be able to select the plus (+) to increase the volume level. The user will CYCLES MODE be able to select the minus (-) to decrease When a wash key is selected (heavy, normal, light, quick, rinse, or spin), the LED shall be lit and remain lit until another the volume level. When the user first presses either of these keys, the current end of cycle signal will be demonstrated. wash cycle is selected. The wash LEDs Subsequent presses of either the plus or do not change during the wash cycle. DELAY MODE The delay start option is primarily used when a person wants to run the washing minus button within 5 seconds of the previous key press will increase or decrease one level. The new end of cycle shall sound. 16010486 (16008373-05) Revised 02/01 Section 2. Washer Controls Overview ©2001 Maytag Appliances Sales Company 2-2