Ricoh 3245 General Settings Guide - Page 152
Auto Colour Calibration
UPC - 026649128660
View all Ricoh 3245 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Troubleshooting Auto Colour Calibration E Press [Start Printing] and a test pat- tern will be printed. If a certain colour is strong or the colour of the copy differs from the original, adjust the yellow, magenta, cyan and black balance. Note ❒ If "DToner is almost empty." is shown on the display panel, the test pattern cannot be printed. A Press the {User Tools/Counter} key. 5 ZFLS110E Note ❒ When performing the auto colour calibration from the printer function, select test patterns from [600 x 600 dpi], [1800×600 dpi] and [1200 x 1200 dpi] and then press [Start Printing]. ❒ The test pattern will be printed on an A4K, 81/2"× 11"K size page (If A4K is not available then A3 L, B4 JISL will be used.). Make sure to check the paper set in the paper tray. ❒ The counter will not proceed when the test pattern is printed. B Press [Maintenance]. F Place the test pattern on the expo- sure glass and press [Start Scan- ning]. The image will be corrected after "Please wait." disappears. C Press [Auto Colour Registration]. D Press [Start] on the "Copier Func- tion". Note ❒ The test pattern will not be read if it is set in the ADF. ❒ Set the test pattern in the following way: Note ❒ When performing the auto col- our calibration from the copy function, press [Start] under Copier Function. When performing from the printer function, press [Start] under Printer Function. 140 GCCLCPIE ❒ When the ADF is installed, make sure to set the test pattern on the exposure glass, and then 2 or 3 white sheets, same size as the test pattern, above the test pattern.