Seagate OneTouch II OneTouch II Installation Guide - Page 27
t the F
View all Seagate OneTouch II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Connecting with the FireWire Cable 3. Find your version of OS X in the table below to determine your Do not plug a FireWire cable into the drive when a USB next step. cable is already connected to the drive. This drive will only operate with one interface at a time. For more information Table 3: Capacity Under 137 GB 2 about the FireWire interface, go to: http://www.1394ta.org. To connect the FireWire cable OS Version Message Your next step 1. Plug one end of the FireWire cable into any available FireWire port on your computer or to any other FireWire device that is connected to your computer. OS X 10.1 Message appears saying OS X is unable to read volume. Go to Step 4. FireWire Ports OS X 10.2 Drive mounts as "Untitled Volume." Open the Apple Disk Utility located in the Utilities folder within the Applications folder on your Macintosh and proceed to Step 5. FireWire Ports Figure 10. Connecting to a FireWire port OS X 10.3 Drive mounts as "Untitled Volume." Open the Apple Disk Utility located in the Utilities folder within the Applications folder on your Macintosh and proceed to Step 5. 2. Plug the other end of the FireWire cable into an available FireWire port on the back of the drive. Depending on the size of your drive, version of OS X, your next step will vary. OS Version OS X 10.1 Table 4: Capacity Over 137 GB Message Your next step Message appears saying OS X is unable to read volume. Go to Step 4. 25