Sharp DC500 FO-DC500 FO-DC525 FO-DC600 Operation Manual - Page 180

Entering and Using Programs Entering and Using Programs If you frequently perform the same operation involving the same party, you can program all the steps of the operation into one Program Key. This allows you to perform the operation by simply pressing that key. ♦ Any Rapid Key which is not already programmed as a Rapid Key or a Group Key can be used as a Program Key. You can include a timer setting in the program to have the operation performed automatically at a selected time. ♦ If the network scanner option is installed, an e-mail, FTP, or Desktop destination can be selected. (This is not possible if a timer setting is included.) ♦ To clear a mistake in the procedures that follow, press STOP . Initial procedure To program a Program Key, first perform the following procedure. After you have completed this procedure, go to the procedure for the specific operation you want to program (see the following pages). 1 Press MENU and then or until PROGRAM/GROUP MODE is selected in the display. MENU MODE 2:LISTING MODE 3:ENTRY MODE 4:OPTIONAL SETTING 5:PROGRAM/GROUP MODE 2 Press START/ ENTER . PROGRAM/GROUP MODE 1:PROGRAM ENTRY MODE 2:GROUP ENTRY MODE 3 Make sure that PROGRAM ENTRY MODE is selected and press START/ ENTER . PROGRAM ENTRY MODE 1=SET 2=CLEAR 4 Make sure that "SET" is selected and then press START/ ENTER . 178 PROGRAM SET PRESS PROGRAM KEY