Sharp DC500 FO-DC500 FO-DC525 FO-DC600 Operation Manual - Page 73
Verification Stamp Option
View all Sharp DC500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
2. Send/Receive Documents Verification Stamp Option 3 Press START/ ENTER and then or until the desired setting is selected. • Note: "TX" stands for "transmission" and "RX" stands for "reception". "AUTO" and "MANU" indicate AUTO and MANUAL reception modes. Settings for Line 1: LINE 1 SETTING 1=TX AND RX (AUTO) 2=TX AND RX (MANU) 3=RX (AUTO) ONLY 4=RX (MANU) ONLY Settings for Line 2: LINE 2 SETTING 1=TX AND RX (AUTO) 2=TX ONLY 3=RX ONLY 4 Press START/ ENTER . 5 STOP Go back to Step 3 to select a setting for the other line, or press to exit. Verification Stamp Option When transmitting a document, you can have the machine stamp each document page as it is scanned. After scanning, you can check to see if all documents have been stamped to verify that no double feeds occurred. (A double feed occurs when two pages are fed through the scanner at once, which means that one of the pages is not scanned.) To use this function, have your dealer install the Verification Stamp option, and then set Option Setting 29 to ON as explained on page page 209. 71