Sharp DC500 FO-DC500 FO-DC525 FO-DC600 Operation Manual - Page 210
Setting 25: BEEP LENGTH, Setting 26: TELEPHONE BILLING CODE, Setting 27: DEPARTMENT CODE DIGITS
View all Sharp DC500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Optional Settings sender's name entered in Chapter 1 will appear). Press or to make the selection and then press START/ ENTER . ♦ Initial setting: OFF Setting 25: BEEP LENGTH This sets the duration of the beep that signals the end of transmission, reception, and copying. Press or to select a duration (3 SECONDS, 1 SECOND, or NO BEEP) and then press START/ ENTER . ♦ Initial setting: 3 SECONDS Setting 26: TELEPHONE BILLING CODE This setting allows you to use Department Codes or direct billing codes for telephone billing on a PBX. (Your dealer must first activate Department Control or direct billing code entry.) Select ON to turn telephone billing on, or OFF to turn it off. Press or to make the selection and then press START/ ENTER . ♦ Initial setting: OFF If you selected ON, the BILLING CODE DIAL selection will subsequently appear. Select BEFORE if your PBX must receive the billing code before dialing a telephone number, or AFTER if it must receive the billing code after dialling a telephone number, and then press START/ ENTER . (Refer to your PBX manual or consult your PBX adminstrator for this information.) Note: If you select AFTER for the BILLING CODE DIAL selection, you must press REDIAL SPEAKER after dialing if you use . Setting 27: DEPARTMENT CODE DIGITS Use this setting if you are using Telephone Billing and need to change the number of digits of Department Codes to accord with your PBX's telephone billing system. Enter any number from 3 to 9 . ♦ Initial setting: 4 208