Sony DPT-S1 Operating Instructions - Page 83

Touchscreen, Digital Paper device Disposal Reference, of Sony Corporation, 1-7-1 Konan Minato-ku Tokyo

Page 83 highlights

 Operation of this device with software other than that provided is not covered by the warranty.  Depending on the types of the text and characters, the text shown on the device may not be displayed properly. This is due to: The capacity of the device. The device is not functioning normally. Content information is written in the language or the character that is not supported by the device.  We do not guarantee all the languages will be able to be displayed properly on your device.  User-created characters and some special characters may not be displayed. Touchscreen  Do not press the screen or screen frame strongly or rub the screen. When operating the Digital Paper device, touch it softly.  You can use the stylus while resting your hands on the touchscreen. When the stylus is near the touchscreen, the finger operation is inactive. Digital Paper device Disposal Reference The built-in rechargeable battery of the device is recyclable. Do not remove the battery yourself; consult the Sony Support Center. For customers in the USA FCC Compliance Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Declaration of Conformity Trade Name: SONY Model No.: DPT-S1 Responsible Party: Sony Electronics Inc. Address: 16535 Via Esprillo, San Diego, CA92127 U.S.A. Telephone Number: 858-942-2230 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.  In order to comply with FCC radio-frequency radiation exposure guidelines for an uncontrolled exposure, this device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption ratio (SAR). Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives This product has been manufactured by or on behalf of Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. Inquiries related to product compliance based on European Union legislation shall be addressed to the authorized representative, Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or 83

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89

83
Operation of this device with software other than
that provided is not covered by the warranty.
Depending on the types of the text and characters,
the text shown on the device may not be displayed
properly. This is due to:
The capacity of the device.
The device is not functioning normally.
Content information is written in the language or
the character that is not supported by the device.
We do not guarantee all the languages will be able
to be displayed properly on your device.
User-created characters and some special
characters may not be displayed.
Touchscreen
Do not press the screen or screen frame strongly or
rub the screen. When operating the Digital Paper
device, touch it softly.
You can use the stylus while resting your hands on
the touchscreen. When the stylus is near the
touchscreen, the finger operation is inactive.
Digital Paper device Disposal Reference
The built-in rechargeable battery of the device is
recyclable. Do not remove the battery yourself;
consult the Sony Support Center.
For customers in the USA
FCC Compliance Statement
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
In order to comply with FCC radio-frequency
radiation exposure guidelines for an uncontrolled
exposure, this device and its antenna must not be
co-located or operating in conjunction with any
other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure
Guidelines.
This equipment has very low levels of RF energy that
are deemed to comply without testing of specific
absorption ratio (SAR).
Notice for customers: the following information is
only applicable to equipment sold in countries
applying EU directives
This product has been manufactured by or on behalf
of Sony Corporation, 1-7-1 Konan Minato-ku Tokyo,
108-0075 Japan. Inquiries related to product
compliance based on European Union legislation
shall be addressed to the authorized representative,
Sony Deutschland GmbH, Hedelfinger Strasse 61,
70327 Stuttgart, Germany. For any service or
Declaration of Conformity
Trade Name: SONY
Model No.: DPT-S1
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego, CA92127
U.S.A.
Telephone Number: 858-942-2230
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation of the device.