Brother International MFC-7050C Users Manual - English - Page 57

Setting the Beeper Volume You can set the beeper to LOW, HIGH or OFF. The default setting is LOW. When the beeper is set to LOW or HIGH, the MFC beeps every time you press a key or make an error, and at the end of fax sending or receiving. 1 Press Function , 1 , 1 , 4 . 2 Press or to select your setting. 3 When the screen displays the setting you want, press Set . 4 Press Stop to exit. Choosing the Handset Volume Before you begin to use the machine, you must decide if you need to set the handset volume to AMPLIFY:ON for a user who is hearing-impaired. VOLUME AMPLIFY: OFF This default setting is appropriate if none of the users are hearingimpaired. During a conversation, users can press L or H on the control panel to adjust the volume. When the handset is replaced, the handset volume will remain until you change it again. VOLUME AMPLIFY: ON-TEMPORARY This setting is appropriate if some of the users are hearingimpaired. During a conversation, users can press L or H on the control panel to adjust the volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset volume returns to the default setting of LOW. VOL AMPLIFY:ON-PERMANENT Choose VOL AMPLIFY:ON-PERMANENT if all of the users are hearing-impaired. During a conversation, users can press L or H on the control panel to adjust the volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset volume returns to the default setting of AMPLIFY. When you press L or H on the control panel to adjust the volume, the display shows the setting you are choosing. Each key press changes the volume to the next setting. Initial Setup Caution It is important that you do not choose PERMANENT unless all the users are hearing-impaired. Otherwise, the default setting of AMPLIFY may damage the hearing of some users. INITIAL SETUP 5-5