Dell PowerConnect 8100 Release Notes - Page 20

DHCPv6 Relay Circuit Id/Remote Id Types

Get Dell PowerConnect 8100 PDF manuals and user guides View all Dell PowerConnect 8100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Switchport Mode Configuration Preserved: When switching between switchport modes (access, trunk, and general), the switchport configuration applicable to the selected mode is maintained. This means that when switching from one mode to another and back, the port will have the same configuration as it had in the original mode. Only the configuration applicable to the selected mode is active on the port.  VRRP The following enhancements have been made to the operation of VRRP to increase usability and robustness of operation in the network: Preemption Delay: Per the VRRP RFC 3768, when preemption is enabled, the backup router discards advertisements until the master down-timer fires. When the preemption delay timer is set to a non-zero value and the backup switch receives a PDU with a lower priority from the master, then backup switch waits for the preemption delay value before advertising itself as the master. Timer Advertisement Learning: In VRRP, all participating routers should be configured with coherent advertisement timer interval values. The operator can now enable timer learning which causes a backup router to learn the master advertisement interval and change its master down interval accordingly. Ping-able VRRP Interfaces: RFC 3768 specifies that a router may only accept IP packets sent to the virtual router's IP address if the router is the address owner (master). In practice, this restriction makes it more difficult to troubleshoot network connectivity problems. This capability adds support for responding to pings by the VRRP master, but does not allow the VRRP Master to accept other types of packets. A configuration option controls whether the router responds to Echo Requests sent to a VRRP IP address. When enabled, the VRRP master responds to both fragmented and un-fragmented ICMP Echo Request packets. The VRRP master responds to Echo Requests sent to the virtual router's primary address or any of its secondary addresses. When the VRRP master responds with an Echo Reply, the source IPv4 address is the VRRP address and source MAC address is the virtual router's MAC address. The VRRP master does not respond to pings sent from the master. Members of the virtual router who are in backup state discard ping packets destined to VRRP addresses, just as they discard any Ethernet frame sent to a VRRP MAC address. Fragmentation and Reassembly: Fragmentation and reassembly of VRRP packets is not supported.  DHCP Relay The following enhancements have been made to the operation of DHCP Relay to bring the implementation into conformance with RFC 4649: DHCPv6 Relay Circuit Id/Remote Id Types RFC 4649 specifies the IANA assignment of the Relay Circuit Id sub-option and Remote Id option. The implementation has been changed so that the administrator can no longer assign a numerical value to these TLVs as the IANA assigned number is now used. The administrator can still enable or disable the insertion of these TLVs in messages sent to the DHCP server. Relay Information Option: 18 System Firmware Version 5.1.0.1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
18
System Firmware Version 5.1.0.1
Switchport Mode Configuration Preserved:
When switching between switchport modes (access, trunk, and general), the switchport configuration applicable to the
selected mode is maintained.
This means that when switching from one mode to another and back, the port will have
the same configuration as it had in the original mode. Only the configuration applicable to the selected mode is active
on the port.
VRRP
The following enhancements have been made to the operation of VRRP to increase usability and robustness of
operation in the network:
Preemption Delay:
Per the VRRP RFC 3768, when preemption is enabled, the backup router discards advertisements until the master
down-timer fires.
When the preemption delay timer is set to a non-zero value and the backup switch receives a PDU
with a lower priority from the master, then backup switch waits for the preemption delay value before advertising itself
as the master.
Timer Advertisement Learning:
In VRRP, all participating routers should be configured with coherent advertisement timer interval values.
The
operator can now enable timer learning which causes a backup router to learn the master advertisement interval and
change its master down interval accordingly.
Ping-able VRRP Interfaces:
RFC 3768 specifies that a router may only accept IP packets sent to the virtual router’s IP address if the router is the
address owner (master). In practice, this restriction makes it more difficult to troubleshoot network connectivity
problems.
This capability adds support for responding to pings by the VRRP master, but does not allow the VRRP Master to
accept other types of packets. A configuration option controls whether the router responds to Echo Requests sent to a
VRRP IP address. When enabled, the VRRP master responds to both fragmented and un-fragmented ICMP Echo
Request packets. The VRRP master responds to Echo Requests sent to the virtual router’s primary address or any of its
secondary addresses. When the VRRP master responds with an Echo Reply, the source IPv4 address is the VRRP
address and source MAC address is the virtual router’s MAC address. The VRRP master does not respond to pings
sent from the master.
Members of the virtual router who are in backup state discard ping packets destined to VRRP addresses, just as they
discard any Ethernet frame sent to a VRRP MAC address.
Fragmentation and Reassembly:
Fragmentation and reassembly of VRRP packets is not supported.
DHCP Relay
The following enhancements have been made to the operation of DHCP Relay to bring the implementation into
conformance with RFC 4649:
DHCPv6 Relay Circuit Id/Remote Id Types
RFC 4649 specifies the IANA assignment of the Relay Circuit Id sub-option and Remote Id option. The
implementation has been changed so that the administrator can no longer assign a numerical value to these TLVs as the
IANA assigned number is now used. The administrator can still enable or disable the insertion of these TLVs in
messages sent to the DHCP server.
Relay Information Option: