Dell PowerConnect 8100 Release Notes - Page 44

Summary User Impact Resolution "no enable authentication" does not disable access to privileged EXEC over the telnet line dot1q_api.c error during MIB walk sFlow Timeout settings for CLI command sFlow: Limit of 32 for the number of interfaces for which sFlow can be enabled sFlow: Formatting errors with some of the records sFlow: The sample Pool field is not being incremented properly sFlow: The sFlow agent field isn't being filled in Stack module inserted in Bay 1 and SFP+ module in Bay 2 CLI "switchport general acceptable-frame-type" different options than GUI startup-config cannot be restored via tftp "show ip ospf database" does not respect configuration of "terminal length 0" Occasionally, "clear config" from console triggers wio_api.c traceback Radius config stops working after reboot. ISDP timers running fast. VRRP hang IPMC error messages and forwarding issue. Dynamic LAG Ports are flapping/continuous trace messages. Simple Switch should have FC enabled by default "no enable authentication" does not disable access to privileged EXEC over the telnet line If LAG port is configured as general trunk then log message is getting printed when snmpwalk is accessing the MIB OID agentLagSummaryAccessVlanID. sFlow receiver timeout value should be optional Current limit of 32 for the number of interfaces for which sFlow can be enabled. Some of the sFlow records had formatting errors. Sample pool field will not be incremented in the sFlow packet sent to the collector. The sFlow agent field isn't being filled into sFlow Packet. With the presence of stack module at bay1, SFP+ module in bay2 will not get detected until the stack-module at bay1 is removed. The CLI "switchport general acceptableframe-type" contains different options than GUI. TFTP script download or saved script validation will leave the DUT in an unusable state. The CLI handler of the "show ip ospf database" command does not consider the terminal length configuration. Occasionally, "clear config" from console triggers wio_api.c traceback Radius config stops working after reboot, needs to be removed and re-added in order to work again. ISDP entries are timing out and dropping off the list before the next update comes in. VRRP loss of mastership causes the switch to hang. Error messages indicating that IPMC table are not set correctly in hardware. Lags do not stay up on combo ports. Enable Flowcontrol on simple mode. Corrected error in authentication processing. Corrected VLAN access error. Changed receiver timeout value to be optional. Changed the limit to allow all sFlow instances. Corrected sFlow header problems. Corrected sample pool field error. Corrected problem adding sFlow agent address. Corrected error that prevented the detecting of SFP+ module in bay 2. Options are now the same. Corrected script validation problem. Corrected terminal length configuration handling. Corrected "clear config" internal message error. Corrected error in Radius user authentication processing. Corrected an error in the ISDP timer disable processing. Corrected an error in the VRRP processing of the new IP address. Corrected error message processing which generated false error messages. Corrected an error in mapping the physical ports to a LACP logical port. Flowcontrol enabled on simple mode. Affected Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms PCM6220 All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms 42 System Firmware Version 5.1.0.1