Dell PowerConnect 8100 Release Notes - Page 34

CLI command "show dot1x users" is missing Missing port membership from SNMP (dot1qVlanStati cUntaggedPorts and dot1qVlanStatic EgressPorts) The VRPP track port priority changes in the running config CLI command "show dot1x users" is missing Changing VLAN configuration for general mode affected trunk mode configuration and there from the port membership returned via SNMP. The VRRP track port priority in the running config is retrieving the operational value instead of the configured value. Corrected the command tree for the "show dot1x users" command. Corrected the issue. Corrected the retrieval of the configured value All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms Firmware won't allow domain names with hyphen "-" in logging email Internal ports are up during most of the switch POST The hyphen is part of the allowed characters Added the hyphen to the available for the email address. allowed characters for email addresses. Internal ports were up while switch is booting, this was causing traffic loss in network. Corrected the initialization of the internal ports. CPLD Code Update is required. 1. Update the CPLD using the command 'dev cpldUpdate' Console#dev cpldUpdate 2. Power cycle the switch. (Power Cycle from CMC WebUI. Do not run "reload" from the console prompt) All 4.2 supported platforms PCM8024-K Continuous log message at default settings DNS client error VRRP Intermittent Connectivity Issues VLAN membership port names not consistent in GUI Radius crash In a Stack, the "show system temperature" CLI command breaks CLI QOS on port channel POE log message comes up during power up sometimes. The meaning of the DNS error message: "DNS Client: osapiSocketRecvFrom returned error for addr 0x1214BCA8" is unclear. Ping to a remote host will not work if switch acts as VRRP master VLAN membership port names are not consistent. Sometimes switch crashes when receiving of Radius packets CLI output for command "show system temperature" is corrupted when pagination is used because the stack displays much more data. There is no way to see the match packet counts of a policy-map on a port-channel. Removed unwanted message. PC7024P/PC7048P Corrected the text of the message. All 4.2 supported platforms Corrected a VRRP communication issue. All 4.2 supported platforms Corrected the port numbers displayed in the GUI. All 4.2 supported platforms Corrected the crash. Corrected the pagination issue. All 4.2 supported platforms All 4.2 supported platforms Command "show policy-map interface port-channel " was added. All 4.2 supported platforms 32 System Firmware Version 5.1.0.1