Dell PowerConnect 8100 Release Notes - Page 41

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes Auto-neg option via Web UI is not grayed out for 10Gb fiber ports. Auto-neg is an option in the port configuration via Web UI for 10Gb fiber ports. Ideally the auto-neg option should be grayed out for 10Gb fiber ports. Auto-negotiation selection is disabled for 10G ports in the Web as auto-negotiation must always be enabled. All 4.2 supported platforms CLI command "show interface detail portchannel1" locks up console session The CLI command "show interface detail port-channel1" generates the following errors: Max number of lines in the scroll buffer reached. Output will be truncated. The scrolling issue has been corrected. All 4.2 supported platforms Creating VLANs, assigning ports using vlan membership detail page causes removal from runningconfig Assigning ACL Priority to a VLAN interface does not get set via Web UI Incorrect Model numbers and revision date in dellref.my Links do not show status M8024 does not save complete MST vlan configuration Need to increase the VRRP routing instances or VRID to greater than 50 On the 8024F, inserting or removing the cable on ports 1 and 2 causes both ports to shut down briefly Using web GUI to create and assign ports via vlan membership detail page causes previous vlan ports and sometimes previous vlan to be removed from running-config. When binding an ACL to a VLAN interface, via Web UI, the "Assign ACL Priority" field does not get set as it would if it were configured via CLI. The last revision date has not been revised. This could lead a customer to believe they do not need to update their MIB file. LAST-UPDATED "200311210000Z" -- 21 Nov 2003 12:00:00 Link dependency CLI "show linkdependency" shows "Member ports" and "Ports depended on" port numbers along with group id, but does not show the status of the members or the depended-on ports. Show spanning-tree mst-config not working. Previous limit was 20. The PowerConnect 8024F ports 1 and 2 will flap briefly when cables are removed and reinserted. VLAN creation addition/removal behavior is corrected. Web interface has been corrected. The MIB has been corrected. Administrators are advised to load the new MIBs when updating to this release. The display has been updated to show the requested information All MSTP configurations are now saved. VRRP instances are now set to 50. All inter-phy operation is fixed. All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms PCM8024 All 4.2 supported platforms PC8024F System Firmware Version 5.1.0.1 Page 39