Dell PowerConnect 8100 Release Notes - Page 25

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes VLAN ACL blocks traffic across stack members Power supply logging 'no ipv4 or ipv6 address found in response for request id' error phone port configuration macro incomplete web session timeout RX Equalizer setting on Stacking ports. interface speed options Change PoE Disconnect Type to DC disconnect stacking with extension modules DHCP Req pkts are not being forwarded to Voice VLAN Component Netlogic memory and B0 CPU support ACL prevented traffic from reaching destination Power Supply messages are only sent to the log file. 'no ipv4 or ipv6 address found in response for request id' error message flooding the switch The phone port is missing some needed commands Web session would timeout regardless of the timeout setting RX Equalizer was not set on the stacking port which caused stacking errors to be reported. Invalid speed options message is not clear PoE controller Disconnect Type was changed to DC Disconnect. Stacking with redundant stack rings caused packet flooding on the stacking links. When using Avaya phone on a switch running dot1x, the phone will NOT get authenticated and thus will not boot Netlogic memory and B0 CPU support Prevented VLAN ACL from being applied to stack ports. Elevated failure messages to ERROR severity Corrected problem that was causing extra error messages to be displayed. Added missing commands to the pone port macro. Corrected the hard timeout to be one hour. Added RX Equalizer value. Changed the message reported when an invalid speed option is input. PoE controller Disconnect Type was changed to DC Disconnect. Corrected problem with stack link queuing. Corrected DHCP forwarding problem. Added support for Netlogic memory and B0 CPU. All 5.0 supported platforms All 5.0 supported platforms All 5.0 supported platforms All 5.0 supported platforms All 5.0 supported platforms All PC70XX Switches All 5.0 supported platforms PC7024P PC7048P All 5.0 supported platforms All 5.0 supported platforms PC8132 PC8132F PC8164 PC8164F Release 5.0.0.4 Summary OpenManage UI does not accept blank space character for port description User Impact Port description does not accept space Resolution Correction the port description validation to accept spaces. Affected Platforms All 4.2 supported platforms System Firmware Version 5.1.0.1 Page 23