Dell PowerConnect 8100 Release Notes - Page 29

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes In stacking environment, "show system temperature" command output is corrupted Error message for port enable / disable on IE on 8024F combo ports Alignment issues in the output of "show voice vlan interface" command CLI command "show ip igmp snooping" output is truncated. vrrp ip command accepts invalid IP addresses CLI command "isdp enable" does not work for a range of ports "show interface Priority-FlowControl" command output is not formatted correctly CLI command "show ip route 192.168.2.2 /24" not ignoring host bits. Port channel goes down during master failover. switches rebooting possible crash dump w/ emWeb CLI output for command "show system temperature" is corrupted when pagination is used. When a copper port was disabled, port was getting set in no negotiating mode. The alignment issues make it difficult for the customer to read the page. The displayed info is not complete on page. Switch allowed user to misconfigure VRRP IP User cannot enable isdp on range of interfaces The user sees the info but it looks messy and is hard to read. The user would not always get the correct list of routes from the "show ip route" command. The members of the stack other than the master unit and their port channels, i.e. the Standby units and their port channel interfaces, are now not affected by a master failover and the port channel stays up during failover. The switch crashes when it receives the url with the maximum characters. Corrected pagination in the command handler. Corrected by disabling negotiation on combo ports Corrected alignment issue Corrected the implementation of this command so that it functions correctly. Added checks to return error when invalid VRRP IP address is given. Added support to "isdp enable" command in interface range mode Corrected formatting issues Corrected the logic in the implementation of the "show ip routes" command so that the appropriate list of routes are shown, depending upon which optional parameters are given. Corrected the logic to check for active port channels in the new Standby master unit. Corrected URL length problem All 4.2 supported platforms PC8024F All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms PC8024 PC8024F PCM8024-K All 4.2 supported platforms All 4.2 supported platforms All System Firmware Version 5.1.0.1 Page 27