Dell PowerConnect 8100 Release Notes - Page 23

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes The PowerConnect M8024-k is the only modular switch that defaults to the simple mode of operation. Simple mode contains a restricted set of commands suitable for control of a port aggregation device that can be deployed in a network without requiring updates to the network by a network administrator. Users needing switch capabilities which require the network administrator to modify the network configuration can exit simple mode using the no mode simple command.  AAA Authentication In prior releases, more than one method could be specified for dot1x authentication even though only the first method was attempted. The CLI and Web now only accept a single method for dot1x authentication. Issues Resolved The following issues from previous releases have been corrected. The issues listed here may have been discovered on any of the switches listed on the title page. Release 5.1.0.1 Summary M6220 crashes when issuing command "show interfaces switchport po1" User Impact Switch crashes when using this command Resolution Fixed memory issue in a loop Affected Platforms All 5.0 supported platforms Cannot apply ACL on VLAN 'out bound' direction from GUI User needed to use CLI Fixed the issue to be able to apply in both directions from the web All 5.0 supported platforms Default VLAN cannot be made static from GUI Cannot change VLAN member Fixed VLAN membership web All 5.0 supported ports settings page platforms Incorrect SFP interface log The wrong port may get messages on stack reported in the trap notification SNMP management IP address can only be set from WebUI and lost after reboot. command is missing in the CLI in Simple Mode Calculate the correct internal interface number Added CLI command support Platforms that support XFP, SFP and SFP+ transceiver modules All 5.0 supported platforms Simple mode In-band IP address missing after reboot. "ip address vlan" command disappears from the runningconfig after reboot Put "ip address vlan" after "port-aggregator group" commands in the text config ARP entries are purged for unknown reason L3 egress objects are not programmed correctly resulting in incorrect L3 forwarding. Use the SDK init function to set defaults for egress object. PCM6220 PCM6348 PCM8024 PCM8024-k All 5.0 supported platforms OOB Static IP unreachable after stack failover After failover stack loses static IP address configured on OOB interface. Proper checks prevent using the previous DHCP mode. All platforms that support the OOB interface System Firmware Version 5.1.0.1 Page 21