Dell PowerConnect 8100 Release Notes - Page 39

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes M8024 - 1GB link being negotiated on 10GB Intel X520-KX4 Feature request Display "clientDUID" in DHCP binding table. The M8024 is negotiating 1GB speed connection with the 10GB X520-KX4 Intel card in the blade server. Issue is only present with new The "Client-DUID" is used to uniquely identify an individual host receiving DHCP address configuration. In the case of a multi-homed host, it is possible to determine that the host has multiple bindings for different interfaces and which interfaces belong to each host. Incorrect pre-emphasis values have been corrected. Client-DUID parameter has been added to show "ip dhcp binding" command output. PCM8024 All 4.2 supported platforms clock summertime recurring EU offset 60 zone "GMT" not offsetting the time by 60 minutes M6220 - Simple mode, VLAN setting not active when move port to another group SSH configuration not restored after reboot PC8024 VLAN trunk assignment CLI change Web UI displays incorrect session timeout duration PC8024 - Secure HTTP Random Characters 4.1.0.6 Time change offset is applied early. Modular switch in Simple mode. Interfaces have VLAN settings different from default. If you move port from one aggregation group to another, VLAN settings are retained and are listed in running config but it is not active until system is rebooted or VLAN information removed and reentered again. SSH config is not restored after reboot. On 4.1.0.6 if VLANS are assigned to a trunk, the switch CLI will display the VLANS not assigned instead of the VLANS that are assigned After the browser session timeout (default 10 minutes), Web UI displays incorrect session timeout duration in the message "Your session had been inactive for more than 240 minutes If you go to system management, Secure HTTP, you will see random characters populating the fields. Even if you delete these entries and re-populate with valid chars, it will repopulate with invalid characters making it impossible to generate a cert using the web interface. Day of month calculation has been corrected. None - issue corrected ssh configuration saved VLANs are displayed in positive format, i.e. assigned VLANs are displayed. The displayed message was corrected. The random character rendering has been corrected. All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms Upgrades to 4.1.0.9 are causing network outages. The wizard from 4.1.0.9 fails to setup interfaces The wizard in 4.1.0.9 fails to create any or very few interfaces and there was no config for any or very few of the ports, thus, the ip, icmp traffic was not working between ports as well. Issue with switch upgrade has been resolved. All 4.2 supported platforms System Firmware Version 5.1.0.1 Page 37