Dell PowerConnect 8100 Release Notes - Page 43

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes Summary IP PIMSM BSR/RP Mapping is not robust Error messages when issuing a show statistics command while traffic running. PCM6348 - Log message output Missing port VLAN membership in the GUI. Routing fails on VLAN. PIM BSR join messages. PIM-SM Not all data passed down to the RPT. Port Configuration page gets errors on 10GB ports when any setting is changed. PIM-SM RP Fails to send Register Stops. IGMPv3 querier sent in error with source address 0.0.0.0 PIM-SM Joining messages using wrong RP address Fails to reconfigure and forward multicast message DNS client error in logs and switch locks up and needs to be rebooted. PIM-DM Prune states expiring. Email alerts do not contain log message. log message "internal interface number 183 out of range" is seen. User Impact When the RP or the BSR changes, the data traffic may get affected and in some case get software forwarded. Accessing unsupported counters causes error messages to be displayed. SNMP walk through unsupported counters cause error messages If switch has less than 24 ports, Port VLAN membership will not be shown in the GUI. Removing a VLAN routing interface causes routing to be lost across the entire switch. PIM Join messages using wrong RP Address When network re-configuration happens, the multicast traffic may not properly converge thus resulting in loss of some traffic. Port Configuration page gets errors on 10GB ports when any setting is changed. Register-Stop messages may not be sent out on the correct interface through to the First Hop Router. Switch will get moved to non-querier mode if an IGMP membership query arrives with source address 0.0.0.0. PIM-SM Joining messages using wrong RP address Switch fails to reconfigure and forward multicast messages following link failure Error message "DNS Client: osapiSocketRecvFrom returned error for address 0xAABBCCDD" being logged The router might end up sending Graft messages even though there are no intended hosts. Current e-mail messages display in e-mail applications with a blank body, log message is not displayed. Message: "nimCheckIfNumber: internal interface number 183 out of range" is displayed. Resolution Corrected RP join processing. Change the logging priority of the messages for unsupported counters so that they are not output. Change the logging priority of the messages for unsupported counters so that they are not output. Corrected the VLAN port data issue. Corrected the VLAN interface removal problem Corrected Join without a Prune condition. Corrected Join condition. Corrected Web page error. Corrected Register Stops message error. Corrected valid address check for membership query packet. Corrected Join message processing. Correct an RPF information problem when link goes down. Corrected error in task that handles changes of the Service Port link status Corrected a PIM-DM timeout error. Corrected error in email header section. Corrected error in VLAN create web page Affected Platforms All Platforms All Platforms All Platforms PC70xx PCM6220 All Platforms All platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms System Firmware Version 5.1.0.1 Page 41