Dell PowerConnect 8100 Release Notes - Page 33

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes "ip http secureserver" command not getting migrated from 4.1.0.19 build to 4.2.1.3 build. Data loop in Simple mode when adding VLAN ip http secure-server command not getting applied when we migrate from 4.1.0.19 to 4.2.1.3 release A data loop occurs in the port-aggregator if a new VLAN is added to an interface. Corrected command parsing problem. Corrected the VLAN creation error. All 4.2 supported platforms PCM6220 PCM6348 PCM8024 PCM8024-k Release 4.2.1.3 Summary The "show fiber opticaltransceiver" command shows LOS even though link is up. Unable to ping with jumbo frames set User Impact The "show fiber optical-transceiver" command was reporting incorrect values when optical transceivers that did not support diagnostics were used. MTU size configured on the combo ports will be lost after a save and reload and also when changes the media preferences are made. Resolution Correct diagnostics so that diagnostics for unsupported transceivers are not displayed. Corrected the storing of the MTU size Affected Platforms All 4.2 supported platforms PC72xx and PC80xx platforms cpCaptivePortal WebLangCode. 1.1 displays en when mib says only supported value active (1) The description of the cpCaptivePortalConfigWebLangCode object doesn't correspond to the values it returns. Corrected the description in All 4.2 supported the fastpath_captive_portal.mx platforms file LLDP Assignment of port ID for PortDescription TLV The CLI shows incorrect media type 10GBASET for fiber ports When Port-Description is set as no description in LLDP port configuration, the TLV should contain the Port Interface name as the port description by default instead of 0. The "show interface advanced firmware" shows incorrect information under "Type" column. Corrected the default PortDescription. Removed the Type column which was not valid. All 4.2 supported platforms All 4.2 supported platforms Can't assign a name to a VLAN No default route or static showing in ip route table Config migration for the "name " command was not correct. "Show ip route" commands will not display route even though there were routes is in the router(static routes, ospf routes) for terminal length 0. Corrected the config migration for the "name " command. Corrected the display of the "Show ip route" command. All 4.2 supported platforms All 4.2 supported platforms System Firmware Version 5.1.0.1 Page 31