Dell PowerConnect 8100 Release Notes - Page 24

http[s] authentication against RADIUS only allows privilege level 1 access HTTPS authentication through RADIUS grants only read-only access. parse RADIUS server response All 5.0 supported properly platforms SNMP v1/2 community manager address no longer functions with network address. When a subnet IP is set as SNMP community IP address then snmp requests from hosts of that subnet are not accepted on the box. Get the mask from the community IP address configured and set it instead of the hard coded value. All 5.0 supported platforms Switch service tag not displayed by "show system id" command Switch service tag not displayed Added retry to get the Service with "show system id" Tag value command M8024-k, M8024, M6348 CLI commands are not authorized after Password Recovery Enabling password recovery will Fixed the issue to enable not allow the user to run CLI commands from serial console commands on the serial console. also All 5.0 supported platforms LINK UP on all interfaces during POST, Links are UP and flapping Changed the CPLD and reset PC8024 and PC81xx during power reset and reloads. logic FCoE -M8024-k setting TSA map to link strict and assigning bandwidth allocation to TC In the CEE mode there is no way to specify the TSA mode in the ETS TLV Check if any weight is configured for the TCGs, if so set the mode to ETS. Platforms running DCBX and including ETS Switch GUI forcing 100Mb speed on External ports when cloning port configurations PowerConnect M6348/General port GUI issue M6348 - service tag not displayed in GUI email addresses with underscore "_" are rejected phone port configuration macro incomplete Switch GUI set all external ports Corrected port speed to 100Mb speed when cloning processing from WEB port configurations. M6348 Vlan membership information on web is displayed and applied incorrectly Service tag shows up as none on GUI A valid email id with an underscore cannot be used The macro never returns and appears to hang Javascript fixed to pick correct enum values Synchronization issue fixed to retry and get the tag information Underscore is now considered valid character Fixed the issue and return error M6348 M6348 All 5.0 supported platforms All 5.0 supported platforms Release 5.0.1.3 Summary Re-enable Auto Negotiation using GUI doesn't work properly User Impact The Auto Negotiation can't be enabled back on "Port Configuration->Show All" page once it has been disabled. Resolution Corrected error in Port Configuration page. Affected Platforms All 5.0 supported platforms 22 System Firmware Version 5.1.0.1