Dell PowerConnect 8100 Release Notes - Page 49

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes Summary User Impact DHCPv6 web issues Potential operator confusion regarding switch configuration. LLDP MED application should not allow configuration of location and inventory transmit TLV's as underlying application not present SysUpTime is not being shown correctly during an SNMP walk (Poll interval 1sec) Log messages need to be corrected on ip dhcp snooping rate limit scenario. The show ip vlan command output is not proper after morequit prompt is encountered, i.e. after around 16 routing interfaces Invalid error port number displayed on log message when vlan is changed to forbidden mode from access mode The banner motd XXXXX does not appear in show running-config Web page mac-vlan table too slow to load. Potential operator confusion regarding switch configuration. Potential operator confusion regarding switch operation. Potential operator confusion regarding switch configuration. Inability to diagnose network issues. Potential operator confusion regarding switch configuration. Potential operator confusion regarding switch configuration. Potential operator confusion regarding switch configuration. Potential operator frustration with switch management. Confused between ip default gateway and ip default route (update manual with how to set a default route). Potential operator confusion regarding switch configuration. Auto Install show boot retry count line needs to be left aligned by one space. Cannot Access Optical Transceiver Diagnostics Page if Multiple Submits done prior to initial refresh completing None. Potential operator frustration with switch management. Error messages for non-existent Potential operator confusion regarding stack members non-informative switch configuration. Resolution The acceptable character sets are documented in the CLI Reference guide. Location and inventory TLVs cannot be enabled for transmission in LLDP MED. Affected Platforms All Platforms All Platforms The correct variable is used All to write SysUpTime Platforms Interface representations in log messages use unit-slotport format. The paging has been corrected. All Platforms All Platforms The error message is no longer issued. All Platforms All banner configuration PCM8024 appear in the running-config For certain browsers, paging has been implemented to speed up load times. The ip default route command is deprecated. Use the ip default route command to set a default route. The retry count alignment is corrected All Platforms All Platforms All Platforms This is a browser dependent issue (IE 6) that is not seen in later versions. The web session recovers after doing a refresh. The user can pre-configure stack units. If the stack unit does not exist for a switch configuration operation, an error message indicating same is issued. All Platforms PC70XX System Firmware Version 5.1.0.1 Page 47