Dell PowerConnect 8100 Release Notes - Page 45

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/ M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes Summary User Impact Need to change message on console when try to downgrade anything below 4.1.0.19 release for new DDR If a switch contains new DDR, downgrading to 4.1.0.19 is not allowed. Resolution Modified the downgrade message. Affected Platforms PCM8024 PCM8024-k (with new DDR) Release 4.1.0.19 Summary Combo ports flapping when fiber port connected to certain other vendor switches New M8024/M8024-k cards have different memory parts requiring changes to DDR timings 10GBaseT ports do not come up Switch crashes when executing "show interfaces detail te1/2/1" command with no space between "te" and the unit/slot/port identifier OOB Default Gateway does not save when using CLI setup wizard Upgrades to 4.1.0.6 are causing network outages. The wizard from 4.1.0.6 fails to setup interfaces The combo port is not coming up after performing repeated plug-out and plug-in. Line "no passive-interface Vl32" in startup-config does not get loaded on startup. Unable to configure Secure Shell from web interface. OpenManage web interface fails to provide an iSCSI web page when selecting the iSCSI item. Wrong information for current link status in port configuration page. User Impact Users unable to reliably operate over combo ports User unable to downgrade to earlier version of firmware Unable to use 10GBaseT ports on PC7048R-RA Service interruption due to crash Resolution Corrected combo port flapping issue with new PHY firmware. Added new media-type command to configure the preference on a combo port No resolution. Newer IOMs do not support earlier versions of firmware. Corrected internal addressing of port. Ports now come up properly. Issue has been corrected. There was no way to configure the gateway on Out-Of-Band interface. Ports on some devices will not attach. The fibers port associated with Fiber / RJ45 combo ports may flap or not link up with certain other switches. The "no passive-interface Vl32" configuration does not get loaded from the startup-config on startup. Proper web page operation is prevented. The web page for iSCSI fails to open when selected with OpenManage. Add functionality for configuring gateway on Out-Of-Band interface. Corrected the Configuration Wizard to properly apply the configuration to all ports. Add commands to allow operator to prefer or force RJ45 or SFP port selection on combo ports. Corrected the loading of the "no passive-interface Vl32" configuration. Web page has been corrected. Web page has been corrected. Incorrect stacking link status is presented Web page output has been in the Web page. corrected. Affected Platforms PC8024 PC8024F PCM8024 PCM8024-k PC7048R-RA M8024 M6220 M6348 M8024-k All Platforms All Platforms PC8024F/ PC8024 All Platforms All Platforms All Platforms PCM6220 System Firmware Version 5.1.0.1 Page 43