Dell PowerConnect 8100 Release Notes - Page 42

The CLI command terminal length is not setting terminal length value The Service tag is being deleted on modular platforms. When executing the command terminal length , the value is not updated after execution. Terminal length settings now take effect immediately. When executing the "show system id" is not The service tag was showing the service tag on modular accidentally being deleted and platforms. is now being saved correctly. All 4.2 supported platforms All 4.2 modular platforms. Release 4.1.1.9 Summary PC7048R-RA switch has boxes req cpu process 38-54% utilization with single power supply. User Impact PC7048R-RA switch has cpu process boxes req running between 38-54 % utilization if it's running either only with primary or secondary power supply. Resolution Corrected CPU utilization issue when running with one power supply. Affected Platforms PC7048R-RA Router crashes on OSPF network type change. Occasional crash when configuring VRRP. Cannot create Dynamic LAG with Interface range command PC8024 cannot forward packets on port9 to port16 while linked on at 100Mb. Show fiber-ports opticaltransceiver is not displaying the correct interface numbers. VRRP routing instances increased to 50. DHCP on in-band and out of band ports Config commands did not migrate correctly from version 3.1.5.13 Auto-neg option via Web UI is not grayed out for 10Gb fiber ports. Simple mode, VLAN setting not active when a port is moved to another group Unable to configure secure SSH from web interface. Secure HTTP Random Characters The switch can crash when changing the configuration from the default of broadcast to point-to-point. With routing globally disabled, bouncing VRRP on a host interface occasionally causes a crash. Dynamic LAG cannot be created from CLI using interface range command. PC8024 cannot forward packets on port9 to port16 while linked on at 100Mb. Instead of reporting on exact ports that had modules, diagnostics were reported on the ports that did not have modules VRRP routing instances increased to 50. The warning message about IP address conflict is not printed in case DHCP is configured on in-band and out-band ports and they both receive an IP address from one subnet. Command "spanning-tree mode mstp" doesn't migrate correctly from version 3.1.5.13. Auto-neg option via Web UI is not grayed out for 10Gb fiber ports for the PCM8024k. if a port is moved from one aggregation group to other, VLAN settings are retained but not applied until reboot. Error message 'sshcfg_load start' missing is returned. Random characters populate the Secure HTTP web page. Corrected process synchronization problem Correct the transition between routing being disabled and routing being enabled. Correct the command syntax to "auto " instead of "active" Correct interoperability problem between the PHY and the switching core. Corrected register problem when accessing the SPF+ ports Increased VRRP routing instances table. Add warning message in case offered IP address is conflicting with the configured one on another port Correct the command tree to migrate the old syntax. Corrected the Web UI. Correct initialization when port is moved. Corrected Web page error. Corrected Web page data initialization. All Platforms All Platforms All Platforms PC8024 PC8024F PCM8024 All Platforms All Platforms All Platforms PCM8024-k PCM6220 All Platforms All Platforms 40 System Firmware Version 5.1.0.1