Dell PowerConnect 8100 Release Notes - Page 30

general mode vlan does not show up after a reload, it shows up in access vlan SNMP OIDs 1.3.6.1.4.1.674.1 0895.3000.1.2.1 10.7.x causing switch crash Stack ARP Problem Stack member units port display is missing in web GUI. No response to ICMP with jumbo (ping) Ports connected to Intel X520 NIC do not return online after reboot. switch reboots randomly The general mode for switchport won't work properly in several cases, such as, script apply, nsf failover and save and reload. Walk of any member of envMonFanStatusEntry and envMonSupplyStatusEntry with 67109251 index causes crash. ARP replies to a routing interface are not received at the CPU after clearing the config and reconfiguring the routing interfaces. Stack member unit ports were not displayed properly. Third IP fragment was being dropped in jumbo Ping packet. When customer is using the Intel X520 NICs, sometimes the ports never came back up after a reboot of the switch. switch reboots randomly Corrected memory initialization problem Corrected unit number range check. Corrected ARP reply policy problem Corrected power LED element id name problem which was causing this display problem. Corrected jumbo Ping packet problem. Corrected port configuration timing issue. Corrected memory corruption problem. All All All PCM8024-K All PC8024 PC8024F All Release 4.2.2.3 Summary IP routing unexpectedly after reboot despite its not having been enabled. Telnet existing session is interrupted when "New Telnet Sessions" is set to "Block". OOB interface unreachable after failover Switch CLI help does not locate the 'initiate failover' command properly User Impact Traffic will get forwarded by software when global routing is not enabled. "New Telnet Sessions" are changed to Block, All the current telnet sessions are closed and using "Telnet Server Admin Mode" to set Disable will only block new telnet sessions. Out-Of-Band interface will be unreachable after a stack failover Warning message printed during execution of the deprecated "movemanagement" command incorrectly states that "initiate failover" command is executed from privileged EXEC mode whereas it's available from stack config mode only. Resolution Correct the default action so that global forwarding is enabled for the hardware. Functionality was corrected so that "New Telnet Sessions" will only block new telnet sessions and "Telnet Server Admin Mode" will close all the sessions if the mode is Disabled. Corrected MAC address for new manager. Corrected the warning message Affected Platforms All 4.2 supported platforms All 4.2 supported platforms PCM6220 PCM6348 PCM8024 PCM8024-k All 4.2 supported platforms 28 System Firmware Version 5.1.0.1