Dell PowerConnect 8100 Release Notes - Page 50

Summary Traffic is forwarding when IPv6 forwarding is disabled User Impact Incorrect operational state in network. A LAG member comes UP if configured individually as no shutdown, even though the port-channel's state is down Incorrect operational state in network. Re-authenticate Now check box is not highlighted when edit check box is selected Inability to configure switch. Block command is not seen in show running config through web and cli Potential operator confusion over switch operations. FDB entries are getting aged out before default age-out time, when both FDB and MFDB tables are full. Potential operator confusion over switch operations. DHCP packets forwarding is not proper to/from the trusted and un-trusted ports Incorrect operational state in network. Configuring all ports in all VLANs takes a long time Max number of OSPF neighbors not supported Cable fault distance not getting displayed in WEB in case of cable with one or more pairs cut or short. Ports representation need to be changed in debug messages No error message for illegal characters in various command parameters The ARP entry is not seen in the ARP table when an ARP reply is sent to DUT. Mapping Table configuration is not being displayed on ReadOnly mode user web page. ACL is getting deleted when trying to create max+1 rule. Potential operator frustration with switch management. Potential operator confusion over switch operations. Potential operator confusion over switch operations. Potential operator confusion over switch operations. Inability to diagnose network issues. Potential operator confusion over switch configuration. Potential operator confusion over switch operations. Inability to diagnose network issues. Potential operator confusion over switch configuration. Potential operator confusion over switch operations. Possible security issues. Resolution The ipv6 forwarding command is deprecated. To disable traffic forwarding, use the "no ipv6 unicast-routing" in place of the "no ipv6 forwarding" command. LAG members are placed in the blocking state for dynamic LAGs and only come up when the LAG link comes up. The Re-authenticate Now check box is highlighted when the edit check box is selected The block command is a temporary administrative assignment and is not maintained persistently in the saved or running configs. On the PCM6220, the MFDB and FDB tables are a shared resource. The user is continually sending new MFDB entries, which causes old FDB entries to be removed to make a place for the new MFDB entries. The frame flooding routing in DHCP snooping now takes into account trust status. VLAN configuration has been optimized. The maximum number of neighbors is supported. The fault distance is displayed in the web page. Affected Platforms PCM8024 All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms All Platforms Ports are now displayed in C/S/P standard format All Platforms The accepted character set and length is documented in the CLI reference manual. ARP entries are stored properly All Platforms All Platforms The mapping table is displayed for a read-only user. Corrected error checking logic. All Platforms All Platforms 48 System Firmware Version 5.1.0.1