Dell PowerConnect 8100 Release Notes - Page 40

PC6220M GUI shows stackports down but CLI does not. In previous version issue didn't exist M6220 Routing fails on VLAN MIB walk crashes switch M8024 - No password min length error using web GUI Bug in Simple Switch GUI. M6348 simple mode issue with 10G ports in aggregator group Banner motd configuration changes after reload. Error message via Web UI refers to "Management VLAN" The issue using CLI stack ports shows up and counters shows no transfer rate but GUI shows stack ports down. Customer has multiple M6220 switches, and as part of a network change they wanted to remove a VLAN routing interface that was no longer in use. When they removed the IP address from this VLAN, they lost routing across the entire switch. SNMP MIB walk crashes switch. On the web GUI-->system-->management security-->password management, If the password min length is unchecked and applied, there is an entry in the running config for "no passwords min-length". This can be verified through CLI. After this, on enable passwords page if we try to set a password which is any length less than 8, we get an error message as shown in the attachment. Once you select the Tagged-Vlans, there is NO way to unselect them again via GUI. Using command-line configuration is the only way to unselect those. Can't remove what running config says is there The "banner motd" configuration changes after a switch reload. Attempting to assign an ACL to VLAN 1, via Web UI, generates an error message referring to the Management VLAN. "Error! Cannot Bind ACLs to Management VLAN." Web shows stack ports up if they are up Ports are now checked to ensure they are not part of other routing VLANs before clearing the ARP policy on the port. A large array is allocated statically instead of on the stack. Password ranges are now allocated dynamically on web pages. Tagged VLANs can be unchecked in simple mode Add interface command is corrected. Previously, the input mechanism ignored ANY lines beginning with an exclamation point. Now, the CLI engine will allow lines with a leading "!" in the banner the hard coded value has been removed in favor of the correct VLAN value All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms All 4.2 supported platforms Web UI not generating error for out bound ACL & applies the config. Binding an IP ACL as out bound to an interface, via Web UI, does not generate an error message. Furthermore, the config gets applied to the interface as an inbound ACL. When the same action is done via CLI, an error message is generated and the config is not applied. Use of the direction object has been corrected. All 4.2 supported platforms 38 System Firmware Version 5.1.0.1