Dell PowerConnect J-SRX210 Hardware Guide - Page 101
Connecting a J-SRX210 Services Gateway to the CLI Locally
View all Dell PowerConnect J-SRX210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Chapter 15: Connecting the J-SRX210 Services Gateway to Management Devices Related Topics • Performing Initial Software Configuration on the J-SRX210 Services Gateway Using J-Web Interface on page 96 • Connecting a J-SRX210 Services Gateway to the CLI Locally on page 85 • J-SRX210 Services Gateway Software Configuration Overview on page 91 • J-SRX210 Services Gateway Secure Web Access Overview on page 101 Connecting a J-SRX210 Services Gateway to the CLI Locally If you plan to use the CLI to configure the J-SRX210 Services Gateway, you must connect through the console port, as shown in Figure 25 on page 85. Figure 25: Connecting to the Console Port on a J-SRX210 Services Gateway J-SRX210 NOTE: Figure 25 on page 85 shows a connection to a local management device. A remote connection to the services gateway through a modem requires the cable and connector shown (provided in the services gateway accessory box), plus a DB-9 female to DB-25 male (or similar) adapter for your modem, which you must purchase separately. To connect to the CLI using a local management device through the console port on the services gateway: 1. Turn off power to the services gateway. 2. Turn off power to the management device, such as a PC or laptop computer, that you are using to access the CLI. 3. Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45 to DB-9 serial port adapter supplied with your services gateway (see Figure 25 on page 85). 85