Dell PowerConnect J-SRX210 Hardware Guide - Page 127
Monitoring the J-SRX210 Services Gateway Using Chassis Alarm Conditions
View all Dell PowerConnect J-SRX210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Chapter 18: Monitoring the J-SRX210 Services Gateway Table 41: Component LEDs on the Services Gateway (continued) LED State Meaning Possible Causes and Corrective Actions Mini-PIM LED Green The Mini-PIM is present and detected Normal condition. No action is by the device. required. Off The Mini-PIM is not present or is not See the "Monitoring the Services detected by the device. Gateway Using Chassis Alarm Conditions" topic under Related Topics. Voice Interface LED Off The port is inactive. Normal condition. No action is required. Green (Steady) The port is active and functioning normally. Normal condition. No action is required. Amber The port is active and not ready for data communication. Normal condition. No action is required. Green (Blinking) The port is active and data communication is taking place. Normal condition. No action is required. Red (blinking) Red (steady) The port is initializing. NOTE: The Voice Interface port LED glows red (blinking) while initializing. If there is an error, the LED remains red; otherwise, the LED changes to green. Normal condition. No action is required. The Port has detected a hardware initialization failure. contact Dell Support. See ""Dell Support"" on page 115. Related Topics • Monitoring the J-SRX210 Services Gateway Chassis Using the CLI on page 107 • Monitoring the J-SRX210 Services Gateway Using Chassis Alarm Conditions on page 111 • Monitoring the J-SRX210 Services Gateway Power System on page 113 • Using the Reset Config Button on the J-SRX210 Services Gateway on page 114 • Changing the Reset Config Button Behavior on the J-SRX210 Services Gateway on page 114 • Dell Support on page 115 Monitoring the J-SRX210 Services Gateway Using Chassis Alarm Conditions When the services gateway detects an alarm condition, the alarm LED on the front panel turns red or amber as appropriate. To view a more detailed description of the cause of the alarm , issue the show chassis alarms CLI command. 111