Dell PowerConnect J-SRX240 Hardware Guide - Page 82
Connecting the J-SRX240 Services Gateway to the CLI
View all Dell PowerConnect J-SRX240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
PowerConnect J-SRX240 Services Gateway Hardware Guide Connecting the J-SRX240 Services Gateway to the CLI If you plan to use the CLI to configure the J-SRX240 Services Gateway, you must connect through the console port as shown in Figure 14 on page 66. Figure 14: Connecting a J-SRX240 Services Gateway to the CLI NOTE: The above figure shows a connection to a local management device. A remote connection to the services gateway through a modem requires the cable and connector shown (provided in the services gateway accessory box), plus a DB-9 female to DB-25 male (or similar) adapter for your modem, which you must purchase separately. Connecting the Services Gateway to the CLI Locally To connect to the CLI using a local management device through the console port on the services gateway: 1. Turn off power to the services gateway. 2. Turn off power to the management device, such as a PC or laptop computer, that you are using to access the CLI. 3. Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45 to DB-9 serial port adapter supplied with your services gateway. 4. Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management device. 66