Dell S2825cdn Users Guide - Page 97

❚ Admin Settings > Network > Advanced Settings > PS Data Format Specifies PostScript 3 Compatible communication protocol for a parallel interface, you can configure the PS Data Format settings for the wired network. The change becomes effective after the printer is turned off and then on again. Auto Standard BCP TBCP Binary Used when auto-detecting the PostScript 3 Compatible communication protocol. Used when the communication protocol is in ASCII interface. Used when the communication protocol is in binary format. Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Used when no special processing is required for data. ❚ Admin Settings > Network > Reset LAN Initializes wired network data stored in non-volatile memory (NVM). After executing this setting and restarting the printer, all wired network settings are reset to their default values. ❚ Admin Settings > Network > Delete All Certificates Deletes all certificates of the printer. After executing this setting and restarting the printer, all certificates are deleted. ❚ Admin Settings > Fax Settings Use the Fax Settings menu to configure the basic fax settings. ❚ Admin Settings > Fax Settings > Fax Line Settings Configures basic settings for the fax line. ❚ Admin Settings > Fax Settings > Fax Line Settings > Fax Number Sets the fax number of the printer to be printed on the header of a fax message. NOTE: • Make sure to specify Fax Number before using Junk Fax Setup. ❚ Admin Settings > Fax Settings > Fax Line Settings > Country Selects the country where the printer is used. ❚ Admin Settings > Fax Settings > Fax Line Settings > Fax Header Name Sets the sender name to be printed on the header on faxes. Understanding the System Menus | 97