HP 750c HP DesignJet 700 user guide - Page 157

RECONFIG. 7 Reconfiguring Your Plotter Changing the Interface Settings and I/O Timeout Setting Network Parallel Serial I/O Setup RS-232-C Full menu mode Changing the Interface Settings With a network interface (such as HP JetDirect Print Server), refer to your network interface documentation for advice on any front-panel configuration. With a parallel interface, no front-panel configuration is necessary. With a serial interface, you should have configured it when installing the plotter, as explained on page 1-29. However, you may need to reconfigure it: When you connect a new computer to the plotter. When you output to the plotter from a new application. If you experience problems with distorted or unintelligible plots. To Change the Serial Interface Settings This task is explained in detail on page 1-29, including a note of the defaults and likely requirements. I/O Setup I/O Timeout Full menu mode To Change the I/O Timeout Setting Some software may not write a proper file terminator at the end of the file. In this case, the plotter will not know that the file is complete and will wait for more data until the end of the "I/O Timeout" period. By default, this period is 30 minutes, but you can change it in the menu (indicated on the left) to as little as 30 seconds. 7-9