HP 750c HP DesignJet 700 user guide - Page 37
Make sure that the leading edge of the media is outside the roll cover
View all HP 750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Setting Up the Plotter Task 4: Load Media 11 a When the front panel instructs you, lift the media lever. b Take hold of the edges of the media now extending from the exit slot and pull the media toward you until taut. Then align the left and right edges of the media so that they are flush with the edges of the roll. B A c When the front panel instructs you, lower the media lever. 0018 12 a When the plotter instructs you to close the roll cover, rewind the media stop in the direction shown by the large arrow below, to take up any slack in the roll. Make sure that the leading edge of the media is outside the roll cover, and then close the cover. SETUP 1 b Press the ↓ key to continue. The plotter automatically trims off the first few inches of media. c The roll media is now loaded and ready for plotting. 1840 1-17