HP 750c HP DesignJet 700 user guide - Page 193

Front-Panel Messages MESSAGES 10 Message Lower lever to continue Lower window to continue Media too small Mispositioned Reload roll Mispositioned Reload sheet MIO data error MIO error Communication Break Open window to access cartridge(s) Out of memory Data was lost Pull # / Align $ edges to roll Remove media Remove media Lower lever Replace cartridge(s) nnnn Reseat cartridge(s) nnnn Roll misaligned Reload roll RS-232 error Baud, parity Explanation and Action You lifted the media lever while the processor was busy. Lower the lever to continue. You opened the window while the processor was busy. Close the window to continue. The media you loaded for accuracy calibration or cartridge alignment is too small. Reload appropriate media. See page 7-5. The roll is mispositioned. Reload media. The sheet is mispositioned. Remove it and reload it with the right edge no more than 0.2 inches (0.5 cm) from either side of the perforated line on the entry platen. The modular interface is incorrectly configured. Press Enter to clear the message from the front panel display. Recheck the MIO configuration settings. The flow of data from the computer to the plotter was prematurely stopped (e.g., by turning off the computer before all data is sent). Press Enter to clear the message from the front panel display. Lift the window to access the cartridge(s). The current plot is too large for the plotter's buffer. Install additional memory to plot this drawing. Grasp the left and right free edges of the roll media and pull toward you until the media is taut. At the same time, align the left and right edges of the media so that they are flush with the left and right edges of the roll. The ink is dry. Remove the calibration plot the plotter just produced. Press ↓ to continue with accuracy calibration. You have attempted to load media while the lever at the right of the plotter was raised. Remove the media, lower the lever, and reload media with the lever down. The cartridge indicated has a clogged nozzle. Replace it to continue. The cartridge indicated is badly seated. Reseat it to continue. Roll media is misaligned (skewed). Reload media. The RS-232-C interface is configured incorrectly. Press Enter to clear the message from the front panel display. Check the baud rate and parity settings in the front panel, in the hardware configuration, and in your software to be sure they are all compatible. 10-3