HP 750c HP DesignJet 700 user guide - Page 195

MESSAGES 10 Front-Panel Messages Message Explanation and Action STATUS The cartridge carriage is returning to its station at the left of the plotter. Returning cartridge(s) STATUS Roll feed edge trim The plotter is trimming the edge of roll media. STATUS Initializing The plotter is doing an internal check during power-up. STATUS Out of media The plotter has received a file, is ready to print, but has no media loaded. STATUS Printing The plotter is printing. STATUS Printing (Special) The plotter is printing with a special print mode controlled by your software rather than by the plotter. STATUS Ready for media The plotter is ready for you to load media. STATUS Ready The plotter is ready to print. STATUS Receiving The plotter is receiving or has received plot data. STATUS Testing cartridge(s) The plotter is testing the cartridge(s) for problems, i.e., clogged cartridge or bad electrical connection (improper seating). Switch power off Turn off the plotter. The cartridge carriage cannot move. The plotter may be Check cartridge path jammed with media. Check the media path and clear it if necessary. Then turn on the plotter. Switch power off Check paper path Turn off the plotter. The drive roller cannot move or the roll feed spindle cannot freely rotate. The plotter may be jammed with media. Check the media path and clear it if necessary. Then turn on the plotter. System error XXXXXX An internal error has occurred and a system error number is displayed. Press Enter; this may clear the error and allow you to continue. If you cannot continue, turn off the plotter, then turn it on again. If you still see the system error message, record the system error number and have the plotter serviced. For support details, see page 9-25. Wrong cartridge type You have loaded one or more incompatible cartridges. Replace the cartridges with those appropriate for this plotter. 10-5