HP 750c HP DesignJet 755CM Printer User's Guide - C3198-60051 - Page 148

Reconfiguring Your Printer Recalibrating Your Printer for Accuracy Utilities Accuracy Recalibrate Full menu mode only To Recalibrate the Printer 1 Choose your media type (sheet or roll). If recalibrating for a non-standard media type, use that type. Otherwise HP Matte Film will give greatest accuracy. 2 Choose your media size. This must be either E/A0 or D/A1. 3 Go to Recalibrate in the front-panel menus, as shown above left. 4 Choose Create pattern. The message Calibrating is displayed. If sheet media is loaded, this will be ejected. If roll media is loaded, you are asked to remove it. 5 When prompted, load your media, using the normal procedure. If using sheet media, load it in portrait orientation, unless you chose D/A1-size media for an E/A0-size printer, in which case load it in landscape orientation. 6 When the calibration print is finished, remove it. 7 Unload any unprinted media. 8 Rotate the sheet 90_ counterclockwise and reload it printed side down, so that the two black arrows go into the printer first. 1 2 3 0030 9 Go to Recalibrate again, and this time choose Measure pattern. 10 When the printer has finished measuring and has ejected the sheet, the recalibration routine is finished. Once created, you can use this calibration sheet to recalibrate the printer's accuracy again later. Store the sheet flat or rolled with the printed side out. If the film takes a curl in the wrong direction it can become impossible to reload. Utilities Accuracy To Restore the Factory's Calibration From the Accuracy menu, choose Restore factory. That's all. Restore factory Full menu mode only 7-6