HP 750c HP DesignJet 755CM Printer User's Guide - C3198-60051 - Page 26
To Load a Roll
View all HP 750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Setting Up the Printer Task 3: Load Media Task 3: Load Media For advice on the availability and use of different media types, see the section starting on page 3-2. IMPORTANT Because the next task is to load the cartridges and carry out the automatic cartridge alignment procedure, you must load opaque media at this stage - for example, coated paper - as this is needed for the alignment procedure. Either of the rolls supplied with the printer is suitable. To load roll media, start with step 1 below. To load sheet media, go to page 1-15. To Load a Roll 1 Make sure the printer wheels are locked (the brake levers pressed down) to prevent the printer from moving. 2 Open the roll cover and remove the empty spindle by pulling firmly on each end. The two ends are different: end A has a media stop and end B a smaller endcap, as shown on the next page. B Roll cover A Place the spindle vertically on the floor, with the media stop at the bottom, ready for the new roll. 1865 1-8