HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 117
Make sure you install the tension bar with the ESD contact ring at the right hand
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
24. At the front of the printer, use the black media advance switch to feed the media (1) on the main scroller enough so that you can install the tension bar in the slack area. NOTE If there is an obvious difference in the amount of media feed between the main scroller and sub-scroller, you should try to adjust the sub-scroller back tension to improve the difference in feed, refer to Adjust the back tension of the sub-scroller 25. Install the tension bar (2) in the supports (1). CAUTION Make sure you install the tension bar with the ESD contact ring at the right hand end of the tension bar (viewed from the front of the printer). NOTE The tension bar is not used for the media on the sub-scroller. How do I use dual media rolls? ENWW Install dual media rolls on separate scrollers 107