HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 316
Heater parameter setup mode
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 316 highlights
Preset temperature Current temperature Front heater AAA XXX Print heater BBB YYY U stands for the temperature unit: C (Celsius) or F (Fahrenheit). The temperature is measured every 5 seconds and refreshed. Display - heater on Rear heater CCC ZZZ When each heater is heated, a plus sign (+) is displayed in place of the unit of each heater current temperature on the second line. The unit display is restored at the completion of heating. In the display example shown above, the front heater is heated. Display - heater off OFF is displayed in the setup temperature display area of the heater that is turned off. The temperature unit of the heater that is turned off is not displayed. The current temperature area is displayed as it is. Tell me about the heaters Display - heater AC power is turned off TURN ON HEATER POWER SWITCH is displayed on the front panel. Heater parameter setup mode This mode is used when the operator sets the heater control system parameters. Setup items and parameters The setup items and parameters are listed in the table below. No. Item Item display Parameters Description (upper line) display (lower line) 1 Temperature unit UNIT CELSIUS - FAHRENHEIT Initial value CELSIUS 306 Chapter 15 Tell me about the heaters ENWW