HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 75
Tighten the printhead fixing screws while applying slight downward pressure on
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
5. Open the cap cover (3) and loosen the printhead fixing screws (1) using the long screwdriver provided with your printer inserted through the hole in the chassis (2). How do I perform basic media operations? 6. Change the height of the printhead by lifting the printhead height lever (1) to lower the printhead, or by lowering it to lift the printhead. 7. Tighten the printhead fixing screws, previously loosened, using the long screwdriver provided with your printer. NOTE Tighten the printhead fixing screws while applying slight downward pressure on the carriage using your hand. 8. Close the rear cover. ENWW Change the printhead height 65
5.
Open the cap cover (3) and loosen the printhead fixing screws (1) using the long screwdriver provided
with your printer inserted through the hole in the chassis (2).
6.
Change the height of the printhead by lifting the printhead height lever (1) to lower the printhead, or
by lowering it to lift the printhead.
7.
Tighten the printhead fixing screws, previously loosened, using the long screwdriver provided with
your printer.
NOTE
Tighten the printhead fixing screws while applying slight downward pressure on the
carriage using your hand.
8.
Close the rear cover.
ENWW
Change the printhead height
65
How do I perform basic media
operations?