HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 134
Use tension bars that are approximately half the width of the media, positioned in the center
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
7. Tighten the three locking screws (1) on each media tube flange to lock the flanges in position. Use the indications on the labels to equally tighten the locking screws. 8. At the rear of the printer, set the white media winding direction switch (1) to the correct position for the direction the media is to be taken-up, inner take-up (A) or outer take-up (B). 9. Install tension bars (1) in the slack area of each media. Use tension bars that are approximately half the width of the media, positioned in the center (widthwise) of the slack area of the media. How do I use dual media rolls? 124 Chapter 3 How do I use dual media rolls? ENWW
7.
Tighten the three locking screws (1) on each media tube flange to lock the flanges in position. Use
the indications on the labels to equally tighten the locking screws.
8.
At the rear of the printer, set the white media winding direction switch (1) to the correct position for
the direction the media is to be taken-up, inner take-up (A) or outer take-up (B).
9.
Install tension bars (1) in the slack area of each media.
Use tension bars that are approximately half the width of the media, positioned in the center
(widthwise) of the slack area of the media.
124
Chapter 3
How do I use dual media rolls?
ENWW
How do I use dual media rolls?