HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 128
in the media sufficient to install the tension bar.
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
7. Use the front panel feed menu to feed enough additional media through the media feederto provide two full turns on the take-up reel (Refer to Perform a manual media feed). 8. At the rear of the printers, set the white media winding direction switch (1) to the OFF position. 9. Turn the take-up reel by hand (in the required direction-for inner or outer take-up) until two full turns have been wound onto the reel. 10. Feed enough additional media through the media feeder to create a slack area (approximately 30 cm) in the media sufficient to install the tension bar. 11. Mount the flanges on the tension bar, refer to Tension bars. 12. Adjust the positions of the flanges (1) on the tension bar, on the take-up side, to the width of the media. How do I use dual media rolls? 118 Chapter 3 How do I use dual media rolls? ENWW