HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 164

How do I print with a liner Double sided printing with a liner CAUTION To avoid potential damage to the printheads, make sure that the carriage height is set to the highest position before printing with a liner (Refer to Change the printhead height). CAUTION If the media width is narrower than the liner width: use the special edge guards to hold down both sides of the media (Refer to Use the special edge guards for use with a liner) and set DETECT WIDTH to NONE (Refer to Media width detection (WIDTH DETECTION)). NOTE Because the liner wrinkles easily, it is recommended that if it is wound onto a take-up reel, only the liner is taken-up, not the printed media. NOTE When using a liner, it is recommended to use the separator bar to separate the liner and the printed media. If a separator bar support assembly is not installed, you must install it to use the separator bar (Refer to Install the separator bar support assembly). The following explanation assumes that the printing on the top side of the media has already been completed. 1. Install a liner roll on the sub-scroller a. Confirm the take-up direction of the liner. b. Install the liner (1) onto the sub-scroller (2). 154 Chapter 5 How do I print with a liner ENWW