HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 155

If the operation finishes successfully, the printer returns to the online or offline state. If it terminates unsuccessfully, an error message will be shown. If this occurs, retry the operation from the step in this procedure where you raised the media load lever. 24. Set the "VACUUM" and "UNSTICK MODE" values with the front panel according to the type of media you are using. Refer to Unstick mode (UNSTICK MODE). NOTE It is recommended to perform a normal printhead recovery before starting to print on the back of the media. Refer to Normal printhead recovery. 25. Print on the back of the media. NOTE The output image from the RIP must be rotated 180º when using this method. Printing on the back of the media from the take-up reel (without relocating from take-up side) To print on the back of the media, you first print on the top side (A), you then cut the media and insert into the feeder again through a space at the bottom of the printer (B). The drying time of a printed side varies depending on the image, so you must verify that the printed side is completely dry before printing on the other side. In general, it is best to dry the printed side for more than three hours. For images with a dark intensity at least 24 hours is required. NOTE A margin of approximately 2.5 m is required at the top edge of the media to print on the back from the take-up reel. NOTE When you print on the top side (A) the take-up is with the printed side on the outside (outer-take-up). How do I perform double-sided printing ENWW Printing on the back of the media from the take-up reel (without relocating from take- 145 up side)