HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 140

130 cm (51 inches) of media wastage at the start of the print job and 80 cm (31.5 inches) of wastage at the end of the job. ● You are working in an area with limited access or the with media rolls that are very heavy meaning handling must be minimized. For this type of print job the best type of double-sided printing to choose is Printing on the back of the media from the take-up reel (without relocating from take-up side) because due to length of media used the risks of image degradation caused by scratches to the top side during the rewind process is increased. The relative amount of media waste is also reduced to an acceptable level when compared to the much greater length of media used for the total print job. This method requires approximately 30 cm (12 inches) of media wastage at the start of the print job and 180 cm (71 inches) of wastage at the end of the job. How do I perform double-sided printing 130 Chapter 4 How do I perform double-sided printing ENWW