HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 72
these later according to the actual media width.
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
4. Put the rubber spacer A (1) on the flange spacer (2). How do I perform basic media operations? 5. Engage the flange spacer and rubber spacer A (2) with the flange stopper and mount them both on the on the scroller (1). If the internal diameter of the media tube is too small to fully engage the flange spacer and rubber spacer A (2), resulting in a large space between flange spacer and the edge of the media tube, use the rubber spacer B (3) to fill this gap. 6. Temporarily install the media tube flanges (1) on the rubber spacers. You will adjust the position of these later according to the actual media width. 7. At the rear of the printer, set the white media winding direction switch to the OFF position. 62 Chapter 2 How do I perform basic media operations? ENWW