HP Designjet 10000s HP Designjet 10000 Series - User's Guide - Page 38

How do I perform basic media operations? Install a media roll in the printer using the main scroller CAUTION Do not touch heater surfaces in the paper path. This may cause burns. Handle media rolls with care. They can be heavy and difficult to move in confined spaces. In some cases, two people should move and install media rolls. Dropping a media roll could cause personal injury or damage to the printer. The printer's front panel messages will guide you through the process of loading media. To install a media roll: 1. Place the media roll (1) on a suitable table or handling cart (2). 2. Adjust the media roll spacer on the main scroller to a position equivalent to the middle (half the width) of the media roll you are going to load. NOTE The media roll spacer stops the weight of the media from causing the roll to sag at the center. a. Remove the two locking screws (1) of the media roll spacer. b. Slide the spacer (3) to the required position on the main scroller (2). There are three positions available, each of which corresponds to the middle position of different width media rolls. c. Replace and tighten the two locking screws (1). 28 Chapter 2 How do I perform basic media operations? ENWW