IBM 4332-004 User Guide - Page 139

Ethernet Menu Item NW FRAME Value AUTO* ETH II 802.2 802.3 SNAP NETBIOS APPLETALK ON* OFF ON* OFF Description Selects the Netware frame type. v AUTO-the printer uses the frame type of the first frame it receives. v ETHER II-the printer uses the Ethernet Standard Version 2 frame type. v 802.2-the printer uses the IEEE 802.2 protocol. v 802.3-the printer uses the IEEE 802.3 protocol. v SNAP-the printer uses the SNAP protocol. Note: This menu item appears only when NETWARE is ON. Turns NetBIOS communications on or off. v ON-enables NetBIOS communications. v OFF-disables NetBIOS communications. Turns AppleTalk communications on or off. v ON-enables AppleTalk communications. v OFF-disables AppleTalk communications. Coaxial SCS Menu Use the Coaxial SCS Menu to define how the printer handles SCS data over the coax attachment. The following table describes the settings you can change from the Coaxial SCS Menu. An asterisk (*) next to a value in the table indicates the factory default. The Coaxial SCS Menu appears only if you have the coax network interface card installed. Notes: 1. To select a new value, press the Enter key when the value is displayed in the message display area. An asterisk (*) appears next to the value in the message display area, indicating that it is now active. 2. Values set in print jobs override Coaxial SCS Menu values set at the printer. 3. For more information about configuring the coax attachment, see Twinax/Coax Configuration Guide. 4. If you are unfamiliar with using the operator panel to work with menus, please read "Using the Operator Panel Keys" on page 23 and "Navigating Menus" on page 24 before continuing. Chapter 6. Operator Panel Menus 127