IBM 4332-004 User Guide - Page 147
Coax Setup Menu, Value, Description, Notes
UPC - 087944489719
View all IBM 4332-004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Coax Setup Menu Item PORT TMEOUT nnn Value IRQ TMEOUT nn HLD TMEOUT nn BUSY TMEOUT nnn EDGE-EDGE OFF* ON Description Specifies the number of seconds the printer waits for data before it determines there is no more data to receive for the job. The printer then checks other installed attachments, and will switch to attachments with jobs waiting. nnn can be from 0 to 255. The default is 90 seconds. 0 dedicates the printer to the coax attachment (the printer will not accept data from other attachments). Note: If you change PORT TMEOUT from 0 to another value, you must submit another coax job or power off and then power on the printer before the new value can take effect. Specifies when an IRQ (intervention required) timeout is sent. This tells the printer how long to wait for an intervention required condition to be corrected before notifying the host of the error. nn can be from 0 to 20 minutes. The default is 1 minute. 0 specifies to never send an IRQ timeout. Specifies the hold timeout value. This value tells the printer how long to wait if the printer is offline for an intervention required condition to be corrected. After this time elapses, the host is notified of the error, unless no other coax jobs are pending. If no other coax jobs are pending, no HLD TMEOUT error notification is sent. nn can be from 0 to 20 minutes. The default is 1 minute. 0 specifies to never send a hold time out. Specifies the busy timeout value. This specifies the amount of time to wait (when the printer is connected to multiple ports) for control to be returned to the coax attachment, before notifying the host. nnn can be from 0 to 999 minutes. The default is 20 minutes. 0 specifies to never send a busy timeout. Turns edge-to-edge printing on or off. v OFF-the printer maintains a border of 4 mm on all four paper sides. v ON-The printer allows printing up to the physical page size. Notes: 1. To prevent toner from contaminating the printer, IBM recommends leaving EDGE-EDGE set to OFF for coax printing; use ON only when necessary. 2. The Coax Setup Menu item EDGE-EDGE applies to SCS data only. To specify edge-to-edge printing for IPDS data, use the EDGE-EDGE item on the IPDS Menu. Chapter 6. Operator Panel Menus 135